Fiberoptisk konverter til DS blitz (3. gen)

Ikelite Ikelite


Ny vare

Fiberoptisk konverter til DS blitz (3. gen) Forstør

Konverterer el-stikket på alle Ikelite DS blitz til en fiberoptisk port.

Flere detaljer

968,00 kr Vejl. udsalgspris: 1 209,66 kr

Producenten skriver:

This 3rd Generation of the Fiber Optic Converter features a hard anodized aluminum plug connection which reduces weight without sacrificing durability. It is recommended for use with any Ikelite strobe produced September 2018 or later with a hard anodized aluminum bulkhead. Read more about the material change here...

Like the 2nd Generation model, this Fiber Optic Converter features heightened sensitivity for use with SEA&SEA or Nauticam housings with internal electrical-to-optical flash triggering devices. These devices translate the camera's electrical signals into a series of LED flashes which are much less bright than a traditional built-in camera flash. The Fiber Optic Converter is also compatible with any system where the camera's built-in flash can be seen by a fiber optic cord.

Attachment and Use 
The Converter simply attaches to the strobe's electrical bulkhead in place of a sync cord connector. The enlarged slave window provides approximately 90 degrees field of view for remote triggering. 

The Fiber Optic Converter automatically configures itself for compatibility with both pre-flash and non pre-flash camera modes. No setting of small switches or confusion over number of pre-flashes. Simply turn on your strobe and take one picture to configure. This adapter is a manual exposure (non-TTL) trigger only. The strobe's output may be adjusted using the manual power settings built into the strobe (varies by model). 

An individual Fiber Optic Converter and compatible cord is needed for each strobe. Use of two strobes requires two Fiber Optic Converters.

This converter attaches to an Ikelite DS strobe. It is not intended to be attached to a housing and will provide no functionality if attached to an Ikelite bulkhead in a housing.

There are two shooting scenarios where the High Sensitivity Optical Slave Converter # 4405 would be a better option:

  • If you're shooting a DSLR or mirrorless camera with Nauticam fiber optic converter and want to shoot at a higher frame rate (4 FPS or faster).

  • If your primary purpose is to trigger your strobes remotely at a distance from the housing without a fiber optic cable in between.

Strobe Compatibility

  • Ikelite DS50, DS51

  • Ikelite DS125

  • Ikelite DS160, DS161 

Fiber Optic Cord Compatibility

  • Ikelite Fiber Optic Coiled Cord # 4501

  • INON Optical D Cable "Non-wireless type" L-Connector

  • SEA&SEA Fiber Optic Cable (L-type) # 50107

  • SEA&SEA Fiber Optic Cable II # 50128

  • Olympus UW Fiber Optic Cable PTCB-E02

  • Nauticam Optical Fiber Cable # 26211 Nauticam to INON

  • Nauticam Optical Fiber Cable # 26212 Nauticam to Sea&Sea

In the Box 
Fiber Optic Converter
Connector protector # 0301.12

Instruction Manual

Ikelite fremstiller undervandshuse til både enkle kompaktkameraer såvel som mere avancerede spejlrefleks- og videokameraer.

Ikelite er berømt for design og fremstilling af de bedste undervandsblitze på markedet og et bredt udvalg af specialtilbehør til undervandsfotografering.